Nowadays, in the face of increasingly fierce market competition, extensive factory management has been seriously out of date. The quality of factory management ...
The residual stress is too high. When the residual stress in the plastic part is higher than the elastic limit of the resin, cracks and cracks occur on the su...
1) The fuel tank volume is too small, the heat dissipation area is not enough, and the cooling device has a small capacity.
2) The dosing pump oil supply sys...
Injection molding is to mold molten plastic into a closed mold with a lower temperature through a nozzle under high pressure. Both thermoplastics and thermosett...
Chinese
